Vanguard ATRT-01_01B S3 - Manual (Page 23)

REV 1 ATRT-01/01B S3 USER’S MANUAL
19
3.6 Performing Tests
3.6.1. Entering Test Record Header Information
You can enter the test record header information before performing tests. The record header
includes identifying information such as the company, station, circuit, manufacturer, etc. Once
the header information has been set, it will apply to all subsequent test records. Follow the
steps below to enter the test header information:
a. Start from the “START-UP” menu:
Press the [2] key (SETUP).
b. The following screen will be displayed:
Press the [1] key (RECORD ID).
c. The following screen will be displayed:
Type the company name using the alpha-numeric keypad.
When pressing a key, the corresponding number on the key will be displayed first.
Pressing the key again will display the first letter on the key. Pressing the key again will
display the second letter on the key. For example, to type the letter “A”, you must press
the
[2] key twice. To erase the character at the cursor position, press the [CLEAR] key.
Press the
[Contrast ∧]
key to move to the next character. Press the
[Contrast ∨]
key to move to the previous character. Press the
[ENTER]
key when you are done
typing the company name.
COMPANY:
_
↑
/
↓
TO POSITION
"ENTER" TO ACCEPT
1. RECORD ID
2. TEST VOLTAGE
3. PRINT RECORD
4. SAVE/RESTORE RECORD
5. SET TIME
6. SET LANGUAGE
1. TEST TRANSFORMER
2. SETUP
3. CALCULATOR
time: 14:21:34
date: 05/24/11