Vanguard DigiTMR - Manual (Page 42)

DIGITMR USER’S MANUAL REV 3
37
3.7.2. Printing the Graphic Test Results
To print the tabulated test results from the last test performed:
a. Start from the “START-UP” menu:
Press the [2] key (GET RSLT) to get the last test results.
b. The following screen will be displayed:
Press the [2] key (PLOT FULL CHART).
NOTES
Option details
• PRINT TEST RESULTS
Prints the tabulated test results.
• PLOT FULL CHART
Graphically plots the entire test results. See Figure 13 for an example.
• PLOT EXPANSION
Can expand the graphic results in 100 millisecond increments. See
Figure 14 for an example.
• PLOT 0 – 200MS
Automatically plots the timing chart from 0 to 200 milliseconds in the
expansion mode with 10 ms timing markers. An example is shown in
Figure 14.
Graphic result interpretations are shown in Figures Figure 15, Figure 16, and
Figure 17.
c. The following screen will be displayed while the graph is being printed:
Figure 13. Typical Graphic Test Results Printout shows a CLOSE timing chart of a circuit
breaker with contact activity on channels 1 and 3. A CT channel is also shown on the
chart. Since the printout was generated to show both Quick-Shot Mode and Time-Travel
Mode, both the CT time and Contact-Travel readings are shown on the chart.
PLEASE WAIT
PLOTTING GRAPH
1. PRINT TEST RESULTS
2. PLOT FULL CHART
3. PLOT EXPANSION
4. PLOT 0 – 200MS
1. TIME BRKR 04/17/09
2. GET RSLT 10:49:23
3. SET-UP
4. DIAGNOSTICS