Vestil ABLT-H-LP - Manual (Page 3)

rev. 12/14/2012 ABLT-H, Manual
Page 3 of 5
Product Specifications by Model:
Model
Capacity in
pounds (kg)
Lowered height
in Inches (cm)
Raised height
in Inches (cm)
Net Weight in
Pounds (kg)
ABLT-H-LP-1-29
1,000
(~455kg)
4
1
/
8
in.
(~10.5cm)
29in.
(~73.7cm)
550 pounds
(250kg)
ABLT-H-LP-2-29
2,000
(~909kg)
4 1 /
8
in.
(~10.5cm)
29in.
(~73.7cm)
560 pounds
(254.5kg)
ABLT-H-LP-3-29
3,000
(~1,364kg)
4
1
/
8
in.
(~10.5cm)
29in.
(~73.7cm)
570 pounds
(259kg)
ABLT-H-LP-4-29
4,000
(`1,818kg)
4
1
/
8
in.
(~10.5cm)
29in.
(~73.7cm)
580 pounds
(264kg)
ABLT-H-LP-6-23
6,000
(`2,727kg)
4
1
/
8
in.
(~10.5cm)
23in.
(~58.4cm)
590 pounds
(268.2kg)
NOTE: Air supply pressure should be at least 60psi and no more than 120psi.
Installation
1. Install the lift table on a level, even surface. Anchor the table to the floor with appropriately-
matched anchor bolts. Measure the diameter of the bolt holes in the base of the frame, and
install bolts that are at least 4in. long to anchor the table to the floor.
2. Shim the table to level it if necessary.
NOTE: Grout should be placed under the table base to resist warping and bending
forces applied to the base between shims. Grout around the entire perimeter
of the base frame.
3. Connect main air supply to the control pedestal. If no control pedestal is supplied, see
schematic for air inlet.
NOTE: Use only clean, dry air. Use of a filter/regulator is recommended.
Lift Table Operation
1. To raise the table.
a. Press the lever on the control pedestal to the “UP” position.
b. Release the lever as soon as the table reaches the desired height.
2. To lower the lift.
a. Press the lever on the control pedestal to the “DOWN” position.
Maintenance:
Install the maintenance stop before inspecting or maintaining the table. Maintenance stop
installation is explained in FIG. 3 below. [NOTE: When performing maintenance beyond merely
applying lubrication to outer surfaces, use overhead rigging to secure the tabletop.]
FIG. 3: Maintenance prop installation
1) Unload the table; then fully raise the table.
2) Loosen the set screw using a
3
/
32
in. Allen wrench.
3) Press the safety stop bolt through the roller guide; then
retighten the set screw.
4) Lower the table until the roller
rests against the safety stop
bolt.
Lever
arm
Attach
padlock
here
FIG. 4: LOCKOUT attachment
point