Vestil BT (20, 40, & 60) - Manual (Page 10)

Step 8: Lower the beam to the ground/supporting surface. Make sure that the beam is not swinging or rotating ,
then slowly lower the beam until it contacts the ground/surface. Lower the load sufficiently to create slack in the
rope/chain. DO NOT remove the beam from the tongs until you appropriately immobilize the beam so that it
cannot roll, fall over, or move in an uncontrolled manner. Disengage the tongs from the beam, and then
disconnect the tongs from the hoist.
In the following photographs, the beam weighs little and lacks dangerous projections that could cause injury, and
thus is easily controlled by the operator. If you cannot easily control BOTH the tongs and beam, find someone to
help you. Furthermore, you should always use the procedure(s) developed by your employer for safely handling
beams.
14 15
16
- 10 -