Vestil PLID - Manual

1
Revised 09-07
A company dedicated to solving ergonomic and
material handling problems since 1955.
VESTIL MANUFACTURING CORPORATION
2999 North Wayne St., Angola, IN 46703
Phone (260) 665-7586 • Fax (260) 665-1339
E-mail: [email protected] • www.vestil.com
POLY LID INSTALLATION
D- AND H-STYLE SELF-DUMPING HOPPERS
INSTRUCTION
GUIDE
Fork Truck Attachments
H-Style Hopper lid bracket installation ............ 2
D-Style Hopper lid bracket installation ............ 3
Installing the hopper lid ............................... 4-5
Contents
Warnings and Safety Instructions ................ 1
Replacement Parts and Receiving .............. 1
Required Tools and Time ............................ 1
WARNINGS & SAFETY INSTRUCTIONS
• Ensure that all employees understand and follow
the following instructions.
• Failure to read and understand these instructions
before installing the lid constitutes a misuse of
the product. All persons involved in performing this
task must be familiar with this material.
• ALL contents must be removed from the hopper before
any work is performed on the hopper.
• Ensure that all information/safety/warning labels stay
in place and remain legible.
• Maintenance and repairs are to be done only by
personnel qualified to perform the required work.
Consideration will not be given for warranty repair
charges without prior written authorization from the
manufacturer.
REPLACEMENT PARTS
We take pride in using quality parts on the
equipment we manufacture. We are not responsible for
equipment problems resulting from the use of unapproved
replacement parts.
RECEIVING INSTRUCTIONS
To order replacement or spare parts for this
equipment, contact the factory.
In any communication with the factory please be
prepared to provide the hopper’s serial number, which is
indicated on the hopper’s dataplate.
It is possible that this replacement part could incur
damage during transit.
Inspect the parts and packaging closely when it
arrives. If you see evidence of damage or rough handling to
either the packaging or to the part when it is being received,
immediately make a note of it on the packing slip!
It is important that you remove the part’s packaging
upon its arrival to ensure that there is no concealed damage
or to enable a timely claim with the carrier for freight damage.
Also verify that the part and its specifications are as
ordered.
REQUIRED TOOLS AND TIME FOR
REPLACEMENT
• Pliers (to install “R” clips)
• Tin snips
• Time Required: approximately 10-15 minutes.
D-STYLE HOPPER WITH
POLY LID INSTALLED
H-STYLE HOPPER WITH
POLY LID INSTALLED