Vestil PLID - Manual (Page 2)

2
H-STYLE HOPPER LID BRACKET INSTALLATION
NOTE: Retrofit lid brackets can be welded or bolted on. If bolting on, holes will need to be drilled in the
hopper chute. The holes in the brackets can be used as a template.
H-Style Hopper shown with lid fully
installed.
Bracket should be
flush with back of
unit.
NOTE: If retrofitting a lid, line the bracket up with the
back of the chute. Then align the bend in the bracket
with the folded lip.
Front lock bar should be 6” from the
front of the chute.
Align the bend in the bracket with the
folded lip (same as above).
*Caution: All holes in bracket should
measure the same height from the edge
of the chute.
Rear hinge bracket.
Bend in bracket
and folded lip
alignment.
Front lock bar bracket.
NOTE: Front lock bar bracket only needs to
be installed if you are going to use the lock
bar and lock lid to prevent unauthorized use
of the hopper.
Rear hinge bracket.
Rear hinge bracket.
Front lock bar bracket.
Optional
bolt holes.
Edge of chute.
Front of chute.