Vestil SWA-48 - Manual (Page 12)

12
C
HANGING
D
ELTA
M
OTOR
S
PEED
C
ONTROLLER
P
ARAMETERS
1) Press to switch to the program mode.
a) The following screen will appear:
Indicating the specified parameter group.
b) Use the following keys to change all parameter settings in Step 2.
2) Important drive parameter settings:
0-
Prog
Data
Prog
Data
MODE
Press "PROG/DATA" key to select parameter group and to store entered data.
"END" displays for approx. 0.5 sec. if input has been accepted.
Press "MODE" to scroll through all status at the drive;
To show the turntable speed on the display, press "mode" three times after
initial power-up. For example, when the turntable is rotating at 12 rpm, the
display will appear as "u 12."
Press "UP" or "DOWN" key to scroll through different parameters.
Press "UP" or "DOWN" key momentarily will change parameter settings in
single-unit increments.
Parameter
0-03
0-05
1-02
1-07
1-08
1-09
1-15
1-16
2-00
2-01
2-02
6-02
6-03
6-04
6-05
7-00
7-01
7-02
Parameter Description
Start-Up Display Selection
User Defined Coefficient K
Maximum Output Voltage
Upper Bound of Freq.
Lower Bound of Freq.
Accel Time 1
Auto Accel / Decel
S-Curve in Acceleration
Source of Frequency Command
Source of Operation Command
Stop Method
Over-Current Stall Prevention Level
Over-Torque Detection Mode
Over-Torque Detection Level
Continuous Output Time Limit
Motor Rated Current
Motor No-load Current
Torque Compensation
Setting
d2
d0.3
d255
d65
d15
d10 *
d0 *
d7
d 3
d 1
d 1
d 150
d3
d 200
d10
d 120
d 75
d 10
Setting Description
Display the content of user-defined unit.
Scales the frequency value so the display shows the
approximate turntable rpm.
Sets the maximum voltage to the motor
Sets the maximum rotation speed with the speed
knob turned fully clockwise (about 11 rpm).
Sets the minimum rotation speed with the speed knob
turned fully counterclockwise (about 3 rpm).
Time to accelerate the motor to the drive's maximum
output frequency setpoint, in seconds.
Allows for a linear acceleration rate of the motor.
Determines how smoothly the drive accelerates.
Allows the turntable speed to be controlled by the
knob of the drive's keypad.
Makes the drive turn on the external foot switch.
Allows the turntable to coast to a stop.
Sets the maximum motor current, as a percentage of
the drive's rated output.
Detection is enabled during Accel and continues until
the Continuous Output Time Limit is reached.
Sets the maximum output torque, as a percentage of
the drive's rated output.
Determines the time the drive will run after over-
torque is detected, in seconds.
Affects the point at which the drive limits its output
current, in percent of drive's rated output.
Affects the drive's motor slip compensation.
Controls the motor's maximum start-up torque.