Vestil SWA-48 - Manual (Page 3)

3
M
ATERIAL
H
OLDER
A
SSEMBLY
14. Unscrew and remove the plastic tension grip handle from the top of
the stretch-wrap material holder rod.
15. Remove the top plastic stretch-wrap material tube retainer (it should
have a bearing pressed into it) from the material holder rod.
16. Remove from the material rod any spacer tubes that will be
necessary for the stretch-wrap material width being used. Leave the
unneeded spacer tubes on the material rod. Subtract from 20" the
width of the material on the roll that will be used -- the difference is
the total length of the rod spacer(s) you will need.
17. Place the material tube onto the material holder rod, lowering it over
the bottom tube retainer. When the roll is correctly mounted onto the
rod, the material should pull from the outer side of the roll when the
material is pulled towards the turntable.
18. Place the top tube retainer into the top of the material tube, and then
drop any needed rod spacer tubes onto the top of the top tube
retainer.
19. Screw the material tension handle onto the top of the material rod.
The tension handle should screw down onto the top of either the
bearing in the top tube retainer or onto a spacer tube.
Longer film rods are available for 40" and 60" material. However, for
material lengths over 20", it will be very difficult to move the mast up
and down due to the counterweight being significantly less than the
weight of the wrap.