Vestil SL-xxx-AA - Manual (Page 5)

5
Receiving Instructions
Every unit is thoroughly tested and inspected prior to shipment. However, it is possible
that the unit may incur damage during transit. If you see damage when unloading, make a
note of it on the SHIPPER RECEIVER.
Remove all packing & strapping material, inspect for damage. IF DAMGE IS EVIDENT, FILE A CLAIM WITH THE
CARRIER IMMEDIATELY! Also, check fork size, type of power unit, etc., to see that the unit is correct for the
intended application.
Warnings & Safety Instructions
Insure that all employees understand and follow the following instructions
•
Read and understand the owner’s manual before using or servicing the stacker.
•
Do not use the stacker if any damage or unusual noise is observed.
•
Improper use of this lift truck could result in injury and damage to load or equipment.
•
Always watch the stacker and any load on it carefully when it is being used or moved.
•
Avoid sudden stops or quick turns to prevent accidental tipping of the load.
•
Load must be centered and evenly distributed on the forks.
•
Park the truck on level surfaces and not in the way of other products
•
When parked, lower the load fork completely.
•
When parked, push E-switch push-button down.
•
Do not perform any modifications to the stacker without the manufacturer’s approval. Failure to receive
authorization for changes to the equipment could void the warranty.
•
Do not use brake fluid or jack oil in the hydraulic system. If oil is needed, use an anti-wear hydraulic oil with a
viscosity grade of 150 SUS at 100°F, (ISO 32 @ 40°C ), or a non-synthetic transmission fluid.
•
Use only replacement parts either supplied or approved by the manufacturer.