Vestil SSH-7939 - Manual (Page 2)

Step 2: Attach the supporting framework to each of the side assemblies.
b
c
a. Position a side assembly (the right
side assembly is shown in photo a) close
to the supporting structure.
b. Slide the free end of each horizontal
support over the connecting tabs of the
side assembly.
c. Fasten the two pieces together with
#12 x 7/8 inch LG Tek screws.
Repeat steps a through c with the other
side assembly.
a
Step 3: Attach the roof assembly.
a a.) Each side of the roof
assembly includes bracket
holes. Notice that the rear
bracket hole is positioned
close to an end, while the
front bracket hole is inset
~8-10 inches from the front
edge of the roof.
b.) Set the roof assembly into
the roof brackets.
c.) Fasten the roof assembly
to each roof bracket with a
2-1/4 inch bolt. Tighten a
nylock nut onto each bolt.
Rear bracket hole Front bracket hole
b c
Step 4: Attach the double-sided bracket to the vertical support.
b
a. Drill holes in the center portion of the double-sided bracket.
Drill a hole approximately 1 inch from each end. Drill 5 more
holes evenly spaced between the top and bottom holes.
Clamp the bracket to the vertical support so that the top of
the bracket aligns with the dotted line shown in photo a
(approx. 1-1/4inch from the top of the horizontal support).
Drill holes in the vertical support that match the holes you just
drilled in the bracket. Start a #12 x 7/8 inch LG Tek Screw in
the top hole of the double-sided bracket. Match the end of
the screw with the top hole in the vertical support.
b. Place a #12 x 7/8 inch LG Tek Screw in each of the
remaining holes.
NOTE: Installing the plastic panels may require some looseness
in the connection between the vertical support and the double-
sided bracket.
a