Vestil SSH-7939 - Manual (Page 3)

Step 5: Install the plastic panels.
a b c
a & b. Slide a plastic panel into the right side of the
double-sided bracket. Notice that each panel is
covered by a thin sheet of plastic. The protective
covering will indicate which side of a panel is the
exterior. Remove the plastic covering from both
sides of each panel. Insert the panel into the
bracket with the exterior side facing outwards. Line
up the top of the panel with the dashed white line
shown in photo b.
c. Slide a single-sided panel bracket onto the free
end of the panel. Align the top of the bracket with
the bottom of the horizontal support (dotted line).
d. Tap the single-sided panel bracket onto the panel
to ensure a secure connection. Clamp the bracket
to the side assembly. Drill a hole at each end of the
bracket and inset them approximately 1 inch. Drill
through the bracket and into the side assembly.
e. Fasten the bracket to the side assembly using
#12 x 7/8 inch Tek screws.
f. Connect the bottom of the panel to the horizontal
support. Drill 3 evenly-spaced holes through each
of the panels and into the horizontal support behind
it.
Wind a rubber-backed washer onto a ¾ inch #10
Tek screw, and then slide a flat washer onto the
screw, and then fasten the panel to the horizontal
support.
g. Slide the top bracket over the top of the panel.
Repeat steps “a” through “g” with the other
panel.
If you had to loosen the screws holding the
double-sided bracket to the vertical support
(step 4), retighten the connections.
d e
g
f