Vestil WL-100 series - Manual (Page 12)

12
HYDRAULIC LOGIC MANIFOLD, DIAGRAM & BOM
• Warning: Care should be taken to identify all potential hazards and comply with applicable safety procedures before
beginning work. Fully lower or secure the platform, and ensure that all system pressure and power have been
removed, before attempting to work on the electrical or hydraulic systems.
• Raise the lift and install the maintenance props before beginning any inspections or work on the unit.
• Only qualified individuals trained to understand mechanical devices and their associated electrical and hydraulic
circuits should attempt troubleshooting and repair of this equipment
• Caution: Do not use brake fluid or jack oils in the hydraulic system. If oil is needed, use an anti-wear hydraulic oil
with a viscosity of 150 SUS at 100°F (ISO 32 @ 40°C), or non-synthetic transmission fluid.