VIAIR 95C - Manual (Page 3)

90C - 92C - 95C Air Compressor Kit
MOUNTING AND WIRING
1. Disconnect ground cable from vehicle’s battery.
2. Temporarily position the air compressor in the location where it will be mounted.
3. Route ground wire to the negative post of the battery or to an appropriate grounding point
and cut ground wire to length as needed.
4. Mount air compressor with the four sets of 13/64” (5 mm) bolts, nuts, washers, and locking
washers provided. Use of thread sealant recommended.
5. IMPORTANT: Please note, your compressor may have a check valve. DO NOT remove
check valve from the unit.
6. Connect compressor’s positive lead wire to one of the leads of your pressure switch.
7. Make sure that your compressor setup is properly fused. For appropriate fuse size,
refer to amp draw of compressor in the specifications section of this manual.
Round up when choosing a fuse.
8. Always locate fuse as close as possible to power source.
9. Before connecting to power source, re-check to make sure that all connections
are properly connected.
10. Connect and test compressor system by running the compressor for a short time to build up
pressure in your air tank.
11. Once air pressure reaches preset cut out pressure of your pressure switch, the compressor
will shut off. Inspect all air line connections for leaks with soap and water solution.
If a leak is detected, the air line may not be cut squarely or pushed all the way in.
Tighten connections if needed.
(Fig. 1) 90C - 92C - 95C Air Compressor Kit Installation Parts List:
A. Mounting Bolts (4pcs)
B. Flat Washers (8pcs)
C. Locking Washers (4pcs)
D. Nuts (4pcs)
E. Inlet Air Filter with Filter Element (1pc) (P/N 00092 only)
F1. Vibration Isolator (4pcs) (P/N 00090 & P/N 00092 only)
F2. Vibration Isolator (4pcs) (P/N 00095 & P/N 02495 only)
G. Ring Terminal (1pc) (P/N 00095 & P/N 02495 only)
(Fig. 2) Compressor
Mounting Hardware
*Refer to Fig. 1 Parts List.
USER MANUAL
A B C D E
A
B
B
C
D
F1
G F1 F2