AMX NXD-CV7 - Manual (Page 19)

CV7 Touch Panel Accessories
11 7" Modero Widescreen Touch Panels
Wiring the NXA-AVB/ETHERNET for Balanced Audio
Professional audio equipment will often use balanced audio inputs and outputs, usually on 3-pin
"XLR" connectors. A balanced audio signal consists of a pair of wires carrying the audio signal in
anti-phase with each other (if one wire carries a positive voltage, the other carries an equal and
opposite negative voltage).
The advantage of balanced audio over unbalanced audio is its ability to reject external interference
added as the signal is carried over the wire. The receiving equipment takes the voltage difference
between the two wires as the input signal. Interference will usually get added to both wires equally,
and so gets cancelled by the receiving equipment.
The 3 wires used in a typical XLR lead are often referred to as Ground, Live (Hot) and Return
(Cold). "Live" and "Return" carry the "in-phase" and "out-of-phase" versions of the audio
respectively. The pins of the XLR plug/socket are as follows:
When connecting the MIC OUT connector to a balanced audio input (FIG. 9), use all three audio
terminals (+, -, and GND), then connect the "+" terminal to the "live" signal, the "-" terminal to the
"return" signal, and the "GND" terminal to the ground signal.
Modero Table Top Cable (CA2250-50)
The CV7 Table Top Touch Panel comes with a standard 10' (3.048 m) Modero cable (CA2250-50)
that supports Ethernet, Audio/Video, and Power connections. The cable comes terminated with two
RJ45 connectors (Ethernet and Audio/Video) and a single 2-pin mini-Phoenix connector for power.
• X = Ground
• L = Live (Hot)
• R = Return (Cold)
FIG. 9 Wiring the rear MIC OUT connector for use with Balanced Audio
FIG. 10 10 Foot Modero Table Top Cable
Balanced OUT
GND
OUT-
OUT+
Ground signal
Return signal
Line signal