AMX NXD-CV7 - Manual (Page 32)

CV7 Touch Panel Accessories
24 7" Modero Widescreen Touch Panels
3. Carefully insert the NXT-BP into the base until the battery securely fits onto the Battery
Connector Port.
Installing the NXA-BASE/1 below an NXT-CV7 Panel
1. Power Off the panel before attempting to attach the NXA-BASE/1.
2. Place the battery base (with battery) onto a flat/level surface.
3. Turn the battery locking slider (FIG. 26) to one side until the locking mechanism is horizontal
to the base (going left to right) and the rear battery latch is pointing directly outward (away
from the LCD).
4. Carefully angle the NXT-CV7 panel over the front alignment pegs (FIG. 27). The pegs assist in
both aligning and securing the panel to the base (the locking mechanism secures the base to
panel when done).
5. Insert the alignment pegs into their corresponding holes below the front of the panel.
6. Verify the alignment of the Panel Interface connectors between the panel (female connector)
and base (male connector) (FIG. 27).
FIG. 26 NXA-BASE/1 showing Panel Interface and connector locations
FIG. 27 NXA-BASE/1 shown aligning with NXT-CV7 panel
Panel Interface
connector (male)
Securing
pegs (2)
Front
Back
Battery
locking
mechanism
Battery
locking slider
Insert holes for
NXT-CV7 feet
Alignment
pegs (2)
(Battery not shown
for illustration purposes)
Alignment
pegs
Battery
locking
mechanism
(with locking
slider)