AMX NXD-CV7 - Manual (Page 75)

Configuring Communication
67 7" Modero Widescreen Touch Panels
Master Connection section - Virtual Master communication over Ethernet
Before beginning:
1. Verify the panel has been configured to communicate either through an Ethernet cable
(connected from either the panel to a valid Ethernet Hub) or wireless to the Wireless Access
Point.
2. Launch NetLinx Studio 2.3 (default location is Start > Programs > AMX Control Disc >
NetLinx Studio > NetLinx Studio 2.3).
3. Select Settings > Master Communication Settings, from the Main menu to open the Master
Communication Settings dialog (FIG. 62).
4. Click the Communications Settings button to open the Communications Settings dialog.
FIG. 61 System Connection page
Obtained
from
NetLinx
Master
When configuring your panel to communicate with a Virtual Master (on your PC) via
Ethernet, the Master IP/URL field must be configured to match the IP Address of the
PC and make sure to use the Virtual System value assigned to the Virtual Master
within NetLinx Studio.
FIG. 62 Assigning Communication Settings and TCP/IP Settings for a Virtual Master
IP Addresses of computer
(also obtained by using the
Start > Run > cmd command)
Enter this IP
into the
Master IP/URL
field on the
System Connection
page