Warner Electric CBC-1550AHFC - Manual (Page 20)

20 Warner Electric • 800-825-9050 819-9050
Press key 0. 01 00.20
25. Press the arrow down key.
02 00.01
Early warning signal, not used.
If it is not 00.01:
Press “RESET/CLEAR”
02 LAtch
Press key 1. 02 00.01
26. Press the arrow down key.
03 00.20
Stop signal of 200ms.
If it is not 00.20:
Press “RESET/CLEAR:
03 LAtch
Press key 2. 03 00.02
Press key 0. 03 00.20
27. Press the arrow down key.
04 00.10
Zero speed signal of 100ms.
If it is not 00.10:
Press “RESET/CLEAR”
04 LAtch
Press key 1. 04 00.01
Press key 0. 04 00.10
28. Press the arrow down key.
05 00.05
Zero speed signal plus 50ms.
If it is not 00.05:
Press “RESET/CLEAR”
05 LAtch
Press key 5. 05 00.05
29. Press the arrow down key.
06 00.05
Zero speed plus second 50ms.
If it is not 00.05:
Press “RESET/CLEAR”
06 LAtch
Press key 5. 06 00.05
30. Press the arrow down key.
08 LAtch
Batch counter auto reset
31. Press the arrow down key
d1 0.10
Zero speed delay #1
If it is not 0.10:
Press “RESET/CLEAR”
d1 0.00
Press key 1. d1 0.01
Press key 0. d1 0.10
32. Press the arrow down key.
d2 0.01
Zero speed delay #2.
If it is not 0.01:
Press “RESET/CLEAR”
d2 0.00
Press key 1. d2 0.01
33. Press the arrow down key.
05P .25
Zero speed window of 250ms
If it is not .25:
Press the arrow right key.
05P .25 (Keep pressing right key until .25)
34. Press the “RUN/PGM” key.
0
35. Make sure pusher is at the “home position.”
36. Toggle the “RUN/JOG” switch to RUN position.
37. Press #1.
38. Press “CLEAR”.
39. Press the yellow start button one time (on the control). The pusher should make one complete
cycle and stop near the “home reference”.
40. Cycle the pusher ten times with the yellow button. Notice that the pusher will increase accuracy
each cycle.
41. If pusher appears to be cycling properly after 10 cycles, press button #8 on the control. Note this
number.
42. Stop cycling. Press “RUN/PGM”.
43. Enter 1000.
44. Press the down arrow. The display shows the “home reference”.
45 Press the down arrow. The display shows the “braking distance” (db).
46. Press “CLEAR”.
47. Enter the “braking distance” you recorded in step #58.
48. Press “RUN/PGM”.