Warner Electric Preassembled Clutch_Brake Module - Manual (Page 4)

4 Warner Electric • 800-825-9050 819-0343
Size 210
A. Mount the UniModule on the Motor Mount so
that the base of the Motor Mount is under-
neath the UniModule and motor (Figure 6). A
pilot diameter on the UniModule mates with a
pilot diameter on the Motor Mount.
B. Secure the Motor Mount to the UniModule
with three (3) bolts provided. (40 to 45 ft. lbs.)
Figure 6
Electrical Connections
To avoid injury (or even
death), always make certain all power is off
before attempting to install or service this
control or any electrical equipment.
The UniModule is provided with one conduit con-
nection hole, threaded for standard 1/2" conduit
connectors. Both the clutch and the brake lead
wires are brought out through this opening. The
conduit box accessory kit, P/N 5370-101-042,
provides two conduit connection holes for stan-
dard 1/2" conduit connectors.
The clutch and brake coils operate on DC volt-
age. Warner Electric offers a full line of AC volt-
age powered controls to meet the needs of
almost every clutch/brake application. The serv-
ice and installation instructions included with
each Warner Electric control show the proper
electrical connections.
Installing the Base Mount
UniModules 2030 and 3040 can be base-
mounted. (Figure 5)
Figure 5
A. Mount each UniModule so that the base is
located below the ventilation holes. A pilot
diameter on the end of each UniModule
mates with pilot diameters on the base.
B. Secure the base to the UniModule with the
four (4) bolts provided. (18 to 22 ft. lbs. for 50
and 180 sizes, 40 to 45 ft. lbs. for 210 size.)
Installing the Motor Mount (M)
A. Motor Mount (M) can be installed to the out-
put end of the UniModule to provide a foot
mounting for the complete assembly of
UniModule and motor.
Size 50, 100, and 180
A. Remove the two (2) long hex head bolts from
the side of the UniModule toward the ventila-
tion holes.
B. Mount the UniModule on the Motor Mount so
that the base of the Motor Mount is under-
neath the UniModule and motor (Figure 6). A
pilot diameter on the UniModule mates with a
pilot diameter on the Motor Mount.
C. Secure the Motor Mount in place with two (2)
longer mounting bolts (30 to 35 ft lbs.) and
the two shorter bolts (18 to 22 ft. lbs.) all pro-
vided in the kit.