Warner Electric PCBC-500 Clutch_Brake Coupling - Manual (Page 14)

E. Assembling the Magnet and Magnet
Hub
1. Determine which side of the magnet hub will be
mounted to the magnet. The hub is reversible.
The side to be used will depend on which side
the taperlock bushing is to enter.
2. Insert the lead wires through the rubber
terminal caps and into the collector ring. The
wires should be inserted from the same side of
the ring that the magnet will be mounted on.
(Figure 8)
3. Mount the magnet to the magnet hub using
capscrews and lockwashers. (Figure 9)
4. Secure the lead wires to the magnet terminals
with screws and lockwashers.
5. Pull the rubber terminal caps over the
terminals.
6. Pull the excess lead wire length from the back-
side of the collector ring (away from the mag-
net) until the wire is snug.
Figure 9
7. Tighten down the screw in the collector ring.
The sharp cone point on the screw should
pierce the lead wire insulation to make a good
electrical contact. The head of the screw should
be below the surface of the collector ring.
(Figure 10)
8. Cut off the excess wire.
Figure 10
Figure 8
Warner Electric • 800-825-9050 819-0484 14