Warner Electric Gen 2 Electro-Module EM-50, EM-100, EM-180 - Manual (Page 7)

7 Warner Electric • 800-825-9050 819-0529
Section D: Mounting the Brake to a Motor
(20, 20FBB)
The brake module (20 or 20FBB) can be
mounted directly to a motor.
1. A hardened key is provided with the mounting
hardware for the module (20 or 20 FBB).
Insert this key onto the motor shaft and prick
punch the end of the motor shaft keyway to
prevent the key from sliding out.
2. Align the motor shaft and key with the mating
shaft hole and key slot in the brake module
(20 or 20FBB). (Figure 8)
3. Secure the brake module (20 or 20FBB) to the
motor C-face with the four (4) long hex head
capscrews provided. Tighten the four (4) bolts
alternately to ensure even alignment of the
module. Tighten them to 30-35 foot pounds.
Section E: Installing the Motor Mount
Bracket (10-20, 10-20FBC, 10-40, 20,
20FBB)
A Motor Mount Bracket can be installed on the
output end of a module (10-20 or 10-20FBC, 20,
20 FBB) or (10-40) to provide a foot mounting for
the complete assembly of an Electro-Module and
C-face motor.
Optional Motor Mount Kit,
Warner Electric part numbers:
EM-50/100................................5370-101-078
EM-180.....................................5370-101-079
1. Mount the bracket to the face of the
Electro-Module underneath the Module
and Motor as shown in Figure 9. A pilot
diameter on the Electro-Module mates with
a pilot diameter on the bracket.
2. Secure the motor bracket in place with four (4)
short bolts and washers provided. Tighten to
18-22 foot pounds.
Section F: Installing the Base Mount
(20-30, 20FBC-30, 30-40)
Model (20-30 or 20FBC-30) and (30-40)
Electro-Modules are designed to be base
mounted as shown in Figure 10.
Optional Base Kit,
Warner Electric part numbers:
EM-50/100................................5370-101-004
EM-180.....................................5370-101-002
Figure 8
Figure 9