Warner Electric Gen 2 Enclosed Module Option User Manual
Enclosed module option, Gen 2, Installation & operating instructions
Vented Warner Electric Modules and base
assemblies can be oriented as necessary to keep
contaminants from entering the open housing
vents.
If an Enclosed Module is required, an optional
Cover Kit (Warner Electric part number
5370-101-076), can be purchased separately
to enclose the open vents in the housing.
Each cover kit includes two (2) vent covers, two
(2) gaskets and four (4) screws needed to convert
a vented Module to an enclosed design
(non-washdown) as shown below.
Note: When using this Cover Kit to enclose the
module, the vent covers should be assembled as
the final step.
Gen 2
Enclosed Module Option
Installation & Operating Instructions
P-273-6
819-0536
Heat Dissipation Curves
Note: When calculating cycles per minute for
Gen 2 50, 100/180 modules, use the Heat
Dissipation Curves above.