American DJ DMX-512 - Manual (Page 10)

PROGRAMMING SCENES:
1. PRESS AND HOLD PROGRAM BUTTON (FIG. 6) for three (3) seconds
to activate program mode. The LCD DISPLAY (FIG.3) will indicate
your in program mode by displaying a continuous fast blinking
light next to ‘PROG.
2. Select a fixture to program, by pressing any or all SCANNER BUTTONS
1 TO 12 (FIG2). Each Scanner Button controls 16 DMX channels,
Faders 1 - 8 on PAGE A and 9 - 16 on PAGE B (FIG. 14).
3. Adjust the faders to the desired settings of the fixture or fixtures your
programming (i.e. Color, Gobo, Pan, Tilt, Speed, etc.), by adjusting
the fader values. Use the PAGE A B BUTTON if your Fixture has more
than eight channels. When selecting from Page A to B you have to
move Sliders to activate channels
4. Once you’ve reached your desired setting and or position for the
Fixture, you can press the SCANNER BUTTON you were adjusting this
stops adjustment of that Fixture(s). You then press another SCANNER
BUTTON
to select another Fixture to adjust.You can adjust more than
one fixture at a time by selecting more than one Scanner Button at
a time
5. Repeat steps 2,3and until all the lights are at the setting you want.
6. When entire scene is set to your liking, press and release the
MIDI / REC BUTTON (FIG 7.) ALL LEDS BLINK 3 TIMES.
8. Then press a SCENE BUTTON 1-8 (FIG 2) to store this scene. The LCD
will display the bank and scene to where your scene was stored.
9. Repeat steps 2-8 to record your first 8 scenes.
10. Now select the bank you want to store your next 8 scenes into by
using the UP and DOWN BANK BUTTONS (FIG.4).
There are 30 banks you can store up to 8 scenes per a bank for a
total of 240 scenes.
11. To exit programming mode press and hold the PROGRAM BUTTON
(FIG.6 ) for 3 seconds.
When you exit programming Blackout LED is on press BLACKOUT BUTTON
to de-activate blackout.
American DJ Los Angeles, CA 90058 - DMX OPERATOR User Manual