Alpine DVA-9965 - Manual (Page 69)

67
-EN
Installing the Power Supply Unit
Caution
Do not block the unit’s fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit
and may cause a fire.
Air ventilation hole
<Side of the Power Supply Unit>
When mounting with Velcro fasteners
When mounting the Power Supply Unit with the Velcro
fasteners, be sure to choose a flat location.
Do not hang the unit from the bottom of the dashboard or rear
deck with the Velcro fasteners.
1
Remove the Protective paper and attach two pieces
of Velcro fastener to the bottom of the Power
Supply Unit.
Power Supply Unit
Protective paper
Velcro Fasteners
(Included)
Protective paper
2
Check the position, and then fix the Power Supply
Unit to the floor carpet.
When mounting with Screws
When mounting the Power Supply Unit with the screws, be sure
to choose a flat location.
When making holes, be careful not to scratch any pipes or wires.
Install the Power Supply Unit on the floor with the
supplied flange-head tapping screws (M4
× 14).
Flange-head tapping screws
(M4
× 14) (Included)
Power Supply Unit