WolfVision VZ-7D - Manual (Page 6)

ZOOM
FOCUS (manual)
IRIS (manual brightness adjustment)
PRESETS (pre-programmable camera settings)
Infrared remote control
IMAGE on / off
Changing the batteries
ADDITIONAL FEATURES OF VZ-7D
6
One of the unique features of WolfVision's portable Visualizers is that there are only 5
buttons on the unit. Therefore anyone can use it without any instructions. For more
experienced users there are some additional functions on the remote control:
The Zoom keys are the most important keys on the IR-
remote control. That is why they are larger than the
other keys. ZOOM keys can also be found on the
camera head of the Visualizer.
When the Focus keys are pressed the Visualizer switches
off the autofocus function. The next time the zoom keys
are pressed the autofocus is switched on again.
When the Iris keys are pressed the Visualizer switches off
the auto iris function. The next time the zoom keys are
pressed the auto iris is switched on again.
Three zoom positions and camera settings can be recalled by quickly (!) pressing the Preset
1,2 or Preset 3 key. A user has the opportunity to store his own presets. By pressing one of
the Preset keys for more than 3 seconds, the present camera and zoom settings are stored
as a preset. Please note that if the Visualizer is not used for a long time the factory presets
reappear when the unit is switched on again.
The Visualizer's image output by the video output (#12) or Y/C-output (#13) can be switched
on and off with these keys. There is absolutely no monitor image distortion when switching on
and off, because the Visualizer actually outputs a black signal in the off position.
If the VZ-7D can only be controlled from a close distance or
if it cannot be controlled at all with the infrared remote
control you may have to change the battery. Open the cover
of the remote control with a flat object (for example a coin or
a big screwdriver) and replace the two 1.5 V AA batteries
with new ones.
-
+
-
+
X X
PRESETS
FOCUS
IRIS
1 2 3
AF
L
A
S
E
R
WIDE TELE
IMAGE
OFF ON
IR-Code
(for specialists only)
To work with more than one Visualizer in the same room, the units should be set to different
ir-codes. To change the infrared codes on the Visualizer, turn DIP-switch 5 to ON (more
details on the DIP-switches, see last page of this manual). To change the infrared code on
the remote control, simultaneously press PRESET 1, PRESET 2 and ZOOM TELE - each
time this key combination is used, the code switches from A to B, (C to D) ... etc. For resetting
the remote control to code A, simultaneously press PRESET 1, PRESET 2 and ZOOM WIDE.
(only code A and B are supported by the VZ-7D)