Extron Electronics VTG 300_300R User Guide Rev. E - Manual (Page 26)

Output type Rate
16:9 HR
(cont.) ............ WSXGA * 55.94 kHz, 1440x900 @ 60Hz
............ WSXGA+1 * 64.67 kHZ, 1680X1050 @ 60Hz
............ WSXGA+2 * 65.29 kHZ, 1680X1050 @ 60Hz
............ 1080P PC 67.20 kHz, 1920x1080 @ 60Hz
............ WUXGA1 * 74.04 kHz, 1920x1200 @ 60 Hz
............. WUXGA2 74.60 kHz, 1920x1200 @ 60 Hz
NOTE: • For NTSC/PAL rates, the component video output is intended for signal
verification and alignment, and should not be used as a reference.
* Firmware 2.05 or higher includes these resolutions. Units with firmware 1.xx
are not able to be upgraded to 2.xx firmware.
Installing the VTG 300 Batteries
Four AA batteries (rechargeable or alkaline) may power the VTG 300 and are easily installed.
With the protective boot removed, use a flat blade screwdriver to loosen the captive screw
and remove the rear battery pack cover. Replace the batteries while observing the correct
polarity molded in the battery cradle as the batteries are installed. Reinstall the cover (see
figure 15 ).
VTG 300 Battery Install.eps
Figure 15. Battery Installation
VTG 300/300R • Operation 20