Extron Electronics System 7SC - Manual (Page 5)

iii System 7SC • Table of Contents
68-499-01 Rev. E
05 09
All trademarks mentioned in this manual are the properties of their respective owners.
Downloading and using projector drivers ...................................................................... 4-16
Key to file names .............................................................................................................. 4-16
Appendix A • Reference Material .................................................................................. A-1
Specifications ....................................................................................................................... A-2
Part Numbers and Accessories .................................................................................... A-5
Included parts ................................................................................................................... A-5
Accessories ......................................................................................................................... A-5
Firmware Upgrade Installation ................................................................................... A-6
Glossary .................................................................................................................................. A-8
FCC Class A Notice
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference, in which case the user will be required to correct the interference at his own expense.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the
unit to ensure compliance.