3 sata drive connection, Figure 4-11: dvi-d/usb kit installation – IEI Integration SPCIE-C2160 User Manual
Page 69
Advertising
SPCIE-C2160 PICMG 1.3 CPU Card
Page 53
Figure 4-11: DVI-D/USB Kit Installation
Step 3:
Mount the DVI-D/USB kit onto the chassis. Once the DVI-D/USB kit is
connected to the board, secure the DVI-D/USB kit bracket to the system
chassis.
4.5.3 SATA Drive Connection
The SPCIE-C2160 is shipped with four SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-12.
Advertising