7 so-dimm installation, So-dimm, Nstallation – IEI Integration TANK-700-QM67 v2.00 User Manual
Page 34: Figure 3-9: so-dimm socket, 7 s o-dimm in s ta lla tio n
TANK-700 Em b e d d e d S ys te m
P a g e 22
3.7 S O-DIMM In s ta lla tio n
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the TANK-700. Please make sure the purchased SO-DIMM complies
with the memory specifications of the TANK-700.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below.
S te p 1:
Remove the bottom panel by removing the five retention screws from the bottom
panel (Figure 3-1).
S te p 2:
Unplug the SATA signal and power cables connected to the TANK-700, and then
place the bottom panel on a flat surface.
S te p 3:
Locate the SO-DIMM socket on the motherboard (Figure 3-9).
Figure 3-9: SO-DIMM Socket
S te p 4:
Align the SO-DIMM with the socket. The SO-DIMM must be oriented in such a
way that the notch in the middle of the SO-DIMM must be aligned with the
plastic bridge in the socket (Figure 3-10).