IEI Integration TANK-720-Q67 - Manual (Page 49)

TANK-720 Em b e d d e d S ys te m
P a g e 37
3.9.14 RS -232 S e ria l P o rt Co n n e c to rs
CN La b e l: COM1, COM2, COM3 and COM4
CN Typ e : DB-9 connectors
CN Lo c a tio n : See Figure 1-3
CN P in o u ts : See Table 3-11 and Figure 3-30
RS-232 serial port devices can be attached to the RS-232 serial ports on the rear panel.
S te p 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Figure 1-3.
S te p 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 3-29.
Figure 3-29: Serial Device Connector
S te p 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.