IEI Integration PPC-37xx-N270 v2.20 - Manual (Page 52)

PPC-37xx-N270 Panel PC
Page 38
Figure 4-13: CD Drive Cover Bracket Retention Screws
Step 4: Attach the CD drive bracket to the CD drive. To do this, align the four retention
screw holes in the CD drive bracket with the retention screw holes on the side of
the CD drive. Insert four retention screws into the bracket on both sides of the
HDD.
Step 5: Install the CD drive into the PPC-3712A by aligning the retention screw holes in
the sides of the CD drive bracket with the retention screw holes on the left panel
and inside the chassis. Insert the three retention screws.
Step 6: Connect the CD-ROM SATA cable and power cable from the connectors on the
motherboard to the rear of the CD drive. Step 0: