IEI Integration TDM_Series v2.01 - Manual (Page 48)

TDM Series Monitor
Page 34
Figure 4-5: USB Touch Screen Connector
4.5 Mounting the TDM Series LCD Monitor
The TDM series LCD monitor can be mounted in a panel, cabinet, rack, or wall. The
monitor can also be mounted on a monitor arm or stand. The mounting methods are
described below.
CAUTION:
When mounting the monitor take care to tighten the retention screws or
bolts until fully secure, but do not over tighten. Over tightening the
retention screws or bolts may cause them to become stripped,
rendering them useless.
4.5.1 Panel Mounting
To mount the TDM series LCD monitor into a panel, please follow the steps below.
Step 1: Select the position on the panel to mount the monitor.
Step 2: Cut out a section of the panel that corresponds to the rear panel dimensions of
the monitor. Take care that the panel section that is cut out is smaller than the
overall size of the metal frame that surrounds the monitor but just large enough
for the rear panel of the monitor to fit through (Figure 4-6).