IEI Integration IVCME-C604 - Manual (Page 43)

IVCE-C608/IVCE-C604/IVCME-C604 Capture Card
Page 15
ƒ Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
ƒ Use the product before verifying all the cables and power connectors are
properly connected.
ƒ Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
5.3 System Requirement
ƒ Microsoft Windows XP
ƒ Microsoft Windows 7
ƒ Microsoft DirectX 9.0c
5.4 IVCE-C608/IVCE-C604 Hardware Installation
5.4.1 Hardware Installation Procedures
To install the video capture card hardware, the following steps must be followed:
Step 1: Install the video capture card.
Step 2: Install the reset cables (optional).
Step 3: Install the GPIO card (optional).
Step 4: Set the rotary switch ID settings.
Step 5: Connect the video and audio devices. Step 0:
Once the steps above have been completed, the hardware installation procedures are
complete.
5.4.2 Video Capture Card Installation
The IVCE-C608 and IVCE-C604 have a PCIe x1 interface. To install the IVCE-C608 and
IVCE-C604IVCE-C608/IVCE-C604/IVCME-C604, please follow the steps below:
Step 1: Align the PCIe edge connector on the bottom of the video capture card with the
PCIe slot on the system motherboard or a backplane.