MoJack EZ - Manual (Page 5)

MoJack EZ Lift MoJack EZ Lift
8 9
Assembly Instructions
STEP 5
Nylock Nut 15
Carriage Bolt 13
Crank Handle 8
Tower 1
Attach the Crank Handle to the Tower by inserting
Carriage Bolt with threads facing up and fasten with
Nylock Nut .
Note: There are two holes in the Crank Handle. The hole
closest to the rubber grip will provide a 6” radius for
cranking. The other hole will provide an 8” radius, making
cranking easier. Use the hole that works best with your
model of lawn mower.
1 8
13
15
Hang the Lift Arm on the Carrier by
hooking the slotted area of the Lift Arm
over the top bar of the Carrier. Insert
Clevis Pin through the hole in
Carrier and lock by fastening the
Small Hair Pin to the Clevis Pin.
Lift Arm 2
Small Hair Pin 18
STEP 6
Clevis Pin 17
2
17
18
STEP 7
Large Hair Pin 19
Wheel Pad, RH 5
Support Rod 9
Ready the Wheel Pads & for installation by
adding Support Rods and Large Hair Pins .
Note: The Support Rods can be configured to fit
several different tire sizes (see Support Rod Guide
for Tire Sizes on page 18). Use appropriate hole
configuration that works best for your model of
lawn mower.
5 6
9 19
STEP 8
Push Pin 16
Lift Arm 2
Wheel Pad, RH 5
Tower 1
Wheel Pad, LH 6
Slide the Wheel Pads & into the Lift Arm .
Insert Push Pins .
Note: The Wheel Pads can be moved in or out to fit
different mower widths. Use the configuration that
works best with your model of lawn mower.
5 6 2
16
THIS COMPLETES ASSEMBLY.
Tower 1
Top Bar
Carrier
Operating Instructions
Before using the MoJack EZ, carefully read this manual in its entirety.
Some steps of the Operating Instructions are repeated from the
Assembly Instructions. The Operating Instructions will show a full
working cycle of the MoJack EZ.