MoJack EZ - Manual (Page 7)

MoJack EZ Lift MoJack EZ Lift
12 13
Operating Instructions
STEP 6
STEP 7
Reverse Front Tires of Mower
(optional – if not applicable, skip to Step 8)
• In some cases, the mower deck or anti-scalping wheels will hit the
Lift Arm while the mower is being raised. This is often the case if
part of the deck (including the anti-scalping wheels) protrudes past
the center line of the front wheels of the mower.
• Rotate the front tires 180° so that they are in the reverse position.
• Remove the Support Rods from the Wheel Pads and slide the
MoJack EZ underneath the mower.
• Secure the Support Rods to Wheel Pads with Large Hair Pins.
Using the MoJack EZ (Steps 8 - 15)
STEP 8
Move Mower onto MoJack EZ
The MoJack EZ must be used on a solid
level surface.
• Drive or roll the mower onto the Wheel Pads.
Stop engine and remove the key.
Adjusting Support Rods for Proper Tire Size
• Adjust Support Rods on Wheel Pads to accommodate the front
tire size of the mower. Please refer to the chart below for proper
Support Rod placement based on the diameter of the mower’s
front tires.
• Secure Support Rods to Wheel Pads with Large Hair Pins.
Reverse
Wheel
Position
Forward
Wheel
Position
Support Rod
Large Hair Pin
See page 18 for more more detailed guide.
10” - 11.5” (25cm - 29cm)
12” - 15” (30cm - 38cm)
15.5” - 17” (39cm - 44cm)
SUPPORT ROD GUIDE FOR TIRE SIZES
STEP 9
Strapping Front Mower Tires to Wheel Pads
• Secure the front mower tires to the Wheel Pads using the Safety
Straps . Secure the hook on the Safety Strap to the Wheel Pad
Cross Bar and insert the Support Rod into the loop on the Safety
Strap by detaching the Support Rod and then sliding the Safety
Strap Loop through and reattaching the Support Rod.
• Tighten the Safety Straps over the top of the tires
to secure mower to Wheel Pads.
Operating Instructions
STEP 10
Adjusting the Crank Handle
(optional)
• The optimal Crank Handle length is in the longer setting. Some
mowers have brush guards or larger hoods that interfere with
the longer Crank Handle. The Crank Handle can be adjusted by
removing the Nylock Nut and Carriage Bolt and re-attaching in
the shorter setting.
STEP 11
Raising the Mower
• Raise the mower by rotating the Crank Handle clockwise.
• See Step 20 for raising the mower with drill attachment.
Do not attempt to lift more than 300 lbs.
The MoJack EZ must be used on a solid level surface.
The engine must be turned off and key removed.
The mower must be in neutral.
The parking brake must be off during this step.
The Safety Straps must be firmly tightened.
10
Wheel Pad Cross Bar
Support Rod
Safety Strap
Nylock Nut
Carriage Bolt
Longer Setting – 8” Radius
Shorter Setting – 6” Radius