MoJack ZR - Manual (Page 2)

MoJack ZR Lift MoJack ZR Lift
2 3
Introduction
Patent pending.
© 2012 (MoJack Distributors, LLC.)
MoJack and the MoJack logo are registered trademarks of MoJack Distributors, LLC.
MoJack ZR is a trademark of MoJack Distributors, LLC. All rights reserved.
This manual contains assembly, parts, operating,
maintenance, adjustment and safety instructions
for your MoJack ZR lift.
BEFORE USING YOUR MOJACK ZR, CAREFULLY
READ THIS MANUAL IN ITS ENTIRETY.
By following these operating, maintenance and safety
instructions, you will prolong the life of your MoJack
lift and promote safe operation.
If additional information is needed, or should you
require a trained service mechanic, contact your
authorized MoJack equipment dealer or distributor.
All MoJack parts are thoroughly tested and inspected
before leaving the factory to ensure that they comply
with all relevant safety standards.
NOTE: Please save this manual for future reference.
NOTE: Location of unit Serial Number.
Warnings and Safety Instructions
IMPORTANT: The MoJack ZR is intended for use with mowers only. Do not exceed 250 lbs. front end weight.
It should never be used to service mowers with a front end weight over 250 lbs.
Submit your questions online at:
www.theMoJack.com
Need Assistance?
Please DO NOT return this product to the store.
Our Customer Service Department is ready to help!
1-877-575-3173
Read and understand all safety and operating instructions before using the MoJack ZR.
Never allow anyone unfamiliar with the safety or operating instructions to use the MoJack ZR.
Follow all safety and servicing instructions provided by the lawn mower’s manufacturer before using the MoJack ZR.
Do not modify the MoJack ZR in any way. Any modifications will void any and all warranties and could compromise
your personal safety.
When using the MoJack ZR, keep ALL bystanders at a safe distance away from the MoJack ZR.
The MoJack ZR must be used on a solid level surface.
Do not lift the front end and the back end of the mower at the same time.
Only use the MoJack ZR for mowers that are less than 250lbs front end weight and properly fits in the provided wheel
pads. (ie. 10” to 17” diameter and within outside wheel measurements of 34” to 43.5”).
Always stop engine and remove key before beginning any work on the mower.
Always place mower in neutral or disengage the hydraulic drive by following the mower owner’s manual.
Never operate the engine while using the MoJack ZR.
Do not exceed the lifting capacity of 250 lbs. front end weight.
If the MoJack ZR shear pin breaks allowing the crank handle to spin freely while lifting the mower, this indicates an
overload condition. Remove the riding equipment immediately.
Scissor Lock must be engaged before starting any service on mower.
Do not remove safety warnings or decals from MoJack ZR.
Before each use, always check for any worn, loose or damaged parts on the MoJack ZR. If any damaged parts are
present, do not use the MoJack ZR and contact MoJack at 1-877-575-3173.
Do not climb on mower while it is lifted, being lifted or being lowered.
No one should be on the mower while it is lifted, being lifted or being lowered.
After the mower is raised to a working height, always place wheel chocks (not included) behind the back tires of
the mower.
Wheel Pads must be set at an equal distance to maintain proper balance.
Remove all mower attachments before using the MoJack ZR.
Some mowers which are equipped with a fuel tank vent may spill fuel when lifted. If this happens, run fuel level down
in the tank to prevent spilling.
Failure to follow these warnings may result in property damage and serious bodily injury or death.