MoJack ZR - Manual (Page 6)

MoJack ZR Lift MoJack ZR Lift
10 11
STEP 6
Operating Instructions
Raising MoJack ZR to Locking Position
• Raise the lift until the lower axle drops into one of the
two notches in the Locking Bar. The locking heights are
approximately 16” and 20” (full height).
• The Locking Bar automatically drops to engage the lower
axle when raising the MoJack ZR.
• When lowering the MoJack ZR, the Locking Bar must be
held up until the lower axle clears the last notch.
Operating Instructions
STEP 9
STEP 7
NOTE: The MoJack ZR is equipped with a clutch to protect
itself from accidental damage. If the Locking Bar is not
disengaged when lowering, the clutch will release the
Crank Handle from the screw and rotate freely. To re-engage
the Crank Handle, turn clockwise for a few turns.
Preparing the Mower for Service
• Place wheel chocks (not included) behind the back tires of the mower.
• Apply the parking brake on the mower.
• The lower axle must be engaged in one of the notches of the
Locking Bar. Wheel Chock
STEP 8
Lowering the Mower
• Remove wheel chocks.
• Release the parking brake.
• Mower must be in neutral or hydraulic
drive disengaged.
• Lift up and hold the Locking Bar and turn the Crank
Handle counterclockwise until the wheel pads are
firmly on the ground. The Locking Bar must be lifted
up until it clears the last notch. It may be necessary
to raise the lift slightly to allow the Locking Bar to be
lifted up.
NOTE: The MoJack ZR is equipped with a clutch to
protect itself from accidental damage. If the Locking
Bar is not disengaged when lowering, the clutch will
release the Crank Handle from the screw and rotate
freely. To re-engage the Crank Handle, turn clockwise
for a few turns.
Removing the Mower from the MoJack ZR
• Remove the Safety Straps from front mower tires.
• Drive or roll the mower off of the Wheel Pads.
STEP 10
Raising the MoJack ZR with a power drill (optional)
The MoJack ZR can be raised or lowered by using a
variable speed corded drill (7 amp minimum) or variable
speed cordless drill (18V minimum).
• The drill will require a 3/8” square driver (not included
but can be purchased at a hardware or home
improvement store).
• Remove Crank Handle.
• Firmly insert the 3/8” square driver in the Square
Receiver. Rotate the drill forward (clockwise) to raise
the Lift Arm and rotate the drill in reverse (counter-
clockwise) to lower the Lift Arm.
• Locking Bar must be lifted and held up until it clears
the last notch.
NOTE: The MoJack ZR is equipped with a clutch to
protect itself from accidental damage. If the Locking
Bar is not disengaged when lowering, the clutch will
release the drill drive from the screw and rotate freely.
To re-engage the drill drive, turn clockwise for a
few turns.
Operator must have a firm grip on the drill before raising or
lowering the Lift Arm.
• Follow all other operating instructions while using the drill attachment.
• Replace the Crank Handle as necessary for future use.
3/8” Square
Driver
Locking Bar
Notches
Lower Axle
Lift Locking Bar
when lowering