Step 8: mount trailer ramps & install rear gate – Northstar Trailers SPORTSTAR III User Manual
Page 12
cotter-pins are installed in side-rail pins. Make sure that at least one leg of
cotter-pin is bent to 90 degrees.
Note: the front brackets run parallel to the front of the trailer and are used to
store/carry trailer ramps.
STEP 8: MOUNT TRAILER RAMPS & INSTALL REAR GATE
a. Mount the trailer ramps (5) on the front corner brackets, and secure the
ramps to the brackets by sliding the ramp pin-bolts through the eyeholes on
each end of the ramps.
b. Secure the ramps to the brackets by inserting the cotter-pins from the
retaining cables.
c. Position the rear gate (11) so that the gate’s pin-slots sit in-between the pin-
slots on the trailer frame.
d. Connect the gate’s pin-slots with those on the trailer using the gate-pins (F).
e. Secure the gate-pins with the cotter-pins, and then secure the cotter-pins by
bending at least one leg to 90 degrees.
YOU ARE FINISHED! We hope that you enjoy your NORTHSTAR TRAILER. Please
contact us at 1-855-375-3088 or email
questions. Our business hours are Monday-Friday 9:00 a.m. to 5:00 p.m. MST.
TRAILER SPECIFICATIONS
Trailer Weight: 670 lbs.
GVWR: 3000 Lbs
Length (w/ tongue): 184”
Width: 84”
Tire Size: 13x185