ODL Tubular Skylight - Manual (Page 8)

8 9
Select the correct hole cutting template for the tube
(10” or 14”).
1
Locate the protruding nail. Use the correct hole-
cutting template to trace the diameter of the outer
template hole.
2
Use a reciprocating/sabre saw to cut the roof hole.
3
Drill a hole inside the traced circle to insert saw blade.
TIP
3
2
1
Carpenter Pencil
Ladder
Safety Equipment
Power Drill
Power Saw
Hole Cutting Template
TOOLS & PARTS
10” Template
14” Template
Rafter
Traced Line
Cut Line
For 14” skylight with 16” on-center rafter spacing, the
14” template will draw a line that overlaps the rafters.
Be sure to adjust your cutting angle to avoid cutting into
the rafters. (See illustration)
IMPORTANT
For 14” skylight with 16” on-center
rafter spacing, see below.
IMPORTANT
See Section 12 for metal roof installation.
See Section 13 for tile roof installation.
Section-4a
On The Roof