Otter Outdoors Pro Ice Cottage - Manual (Page 2)

Page 2
3. Place the seat rail bracket (Item 20) on the first hole and mark second hole location. Note: Bracket for front of
sled has a different bend then the rear of sled. Drill the remaining two 5/16” holes through the sled. Do not attach
the brackets to the sled at this point. Ref. Diagram 2.
Diagram 2
20
Mark second hole and drill 5/16”
Front of sled
bracket
Rear of sled
bracket
First hole
Tools Required:
7/16” Box End Wrench 3/8 Bit
7/16” Socket and Ratchet 5/16 Bit
Drill/Driver
Phillips Bit
3/32 Drill Bit (optional)
Complete Pkg Only
1/2” Wrench
1/2” Socket
1. Layout all parts. Position sled as shown. Skip pages 2-4 if not assembling the complete package.
2. Measure 17” from the front/left corner of the sled and 1-1/2” down and mark the location for the top hole needed
for the seat rail bracket (Item 20). Measure 17-1/2” from the rear/left corner of the sled and 1-1/2” down and
mark the location for the top hole needed on the other side. Check bracket placement to be sure brackets are
either flush with top edge of sled or below the edge. Drill the two 5/16” holes through the sled. Ref. Diagram 1.
Diagram 1
Front
17 in.
1-1/2 in.
1-1/2 in.
17-1/2 in.
Rear
Right
Left