Otter Outdoors Pro Ice Cottage - Manual (Page 5)

Page 5
8. Position sled (Item 1) as shown
in Diagram 7 with curved front
to your left. Using front drilling
pattern (on back page) mark
two holes for the front frame
bracket with a sharp object.
Using rear drilling pattern (on
back page), repeat this step for
the rear frame bracket.
9. Drill the 4 marked holes using a
5/16 bit.
10. Drill the 3/8 in. hole in center of
lip approximately 16 inches from
bend in sled. The back wind
support bar (Item 5 not shown)
is to be propped here. Ref
Diagram 7.
Diagram 7
Diagram 8
Item 25 - 5/16 Washer
Item 28 - 1/4 Nylon Hex Lock Nut
11. Bolt frame brackets (Item 3 and Item 4) to sled using holes predrilled in Step 9.
Use appropriate fasteners shown in Diagram 8.
Place front and rear drilling
patterns in these corners.
16 in.
3/8 in.
Hole
1
3
25
28
4
Seat and Seat Rail
not shown for clarity.