Adendum, 1 connectors pin-out, 2 cable management – Pacific Laser Equipment 1SA-1000 User Manual
Page 16
Advertising
Servo Amplifier 1ch-1000
User manual
1SA-1000
April 28, 2004
Release: 1.21
2003 by
Pacific Laser Equipment
PLEquipment, 3941 S. Bristol St. Unit E, # 122, Santa Ana, CA. 92704, ( & Fax: 509-355-5155, Email: [email protected]
Page 16 of 16
10.Adendum
10.1 Connectors pin-out
Output voltage range 0V to -1200V DC (negative polarity) is sent through a coax cable with the
center potential swings between 0 to –1200V. The shield is connected to the chassis of the
electronics and to the ground of the power plug. The connectors are LEMO type and extension
cables can be purchased if needed. The sensor connectors
10.2 Cable management
To use the system in a vacuum chamber one can cut the cable and solder it on the inside and
the outside of the feed-through
Advertising