Pacific Laser Equipment 1SA-1000 - Manual (Page 3)

Servo Amplifier 1ch-1000 User manual
1SA-1000
April 28, 2004 Release: 1.21 2003 by Pacific Laser Equipment
PLEquipment, 3941 S. Bristol St. Unit E, # 122, Santa Ana, CA. 92704, ( & Fax: 509-355-5155, Email: [email protected]
Page 3 of 16
1. Introduction
Product description
The 1SA-1000 is a unique piezo actuator driver.
It consist of is a precision high voltage amplifier with integrated servo controller electronics.
On the front panel the device offers manual control as well as an analog input for user control.
All front panel connectors have the outer side connected to ground (GND).
The HV output connector will deliver up to –1200V (negative polarity) on the center pin.
For applications where PC control is necessary we suggest the use of a D/A card to generate
the analog input voltage. Suggested manufacturers are Capital Equipment Corporation (CEC),
Keythley Instruments and National Instruments (NI).
The actuator expansion can be visually monitored on the front panel digital display or through
the analog monitor output, also available on the front panel through a BNC connector.
The equipment is pre-calibrated and the user seldom needs to adjust, one time, the “ZERO
CALIBRATION” potentiometer on the front panel.
On the rear panel the user has access to the AC power plug and a slow-blow fuse.
Labels:
Rear panel two labels display the power requirements and the unit serial number.
Top cover the label shown bellow displays a “map” of the front panel controls and connectors.
Front panel the model number and company name are displayed.