Poly-Tex Poly-Vent (Retrofit) - Manual (Page 18)

18
"THIS SIDE UP" DECAL
This drawing illustrates where to locate the air inlet(s) on your Poly-Vent.
POLY-VENT II
BLOWER
TOP
BOTTOM
POLY-VENT III
BLOWER
(OPTIONAL)
1. The flex tubing is attached to the very top tube of the Poly-Vent. A decal will show which tube to locate the flex
tubing connection.
2. Poly-Vent III requires two blowers. An additional decal will show which tube to locate the lower flex tubing connection.
"INSTALL FLEX HOSE
IN THIS TUBE" DECAL
"INSTALL FLEX HOSE
IN THIS TUBE" DECAL
INSTALL FLEX HOSE
IN THIS TUBE
INSTALL FLEX HOSE
IN THIS TUBE
REAR PANEL
POLY-VENT