Probuilt Professional Lighting Wobblelight 85w - Manual

Manufactured by ProBuilt Professional Lighting: 877-707-0800
Thank you for purchasing Wobblelight ® WL85F
IMPORTANT SAFETY INSTRUCTIONS
WARNING !!!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
SAVE THESE INSTRUCTIONS
QUESTIONS OR PROBLEMS?
Call ProBuilt Professional Lighting Customer Service and Technical Support at 877-707-0800 (Monday-Friday from 8:30 a.m. until 5 p.m. Central
time) or e-mail
[email protected] anytime.
This manual contains important safety and operating instructions for Wobblelight ® WL85F portable lighting. Before using Wobblelight ® WL85F please review all of
the following safety instructions carefully and read all labels on the Wobblelight ® WL85F unit.
INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS:
WARNING: To reduce the risk of fire, electric shock, or injury to persons:
 DO NOT connect Wobblelight ® WL85F to power source until the bulb is installed and the unit is completely assembled.
 DO NOT attempt to remove the protective lens to change bulbs unless the Wobblelight ® WL85F unit is disconnected from the power source and the bulb
has completely cooled.
 Not for use in wet locations. DO NOT use Wobblelight ® WL85F where there is potential for exposure to excessive moisture from rain, snow, ice, water
spray or standing water.
 Connect Wobblelight ® WL85F only to 120 volt, 60 Hz power source which is protected with a ground-fault circuit interrupter (GFCI) and over-current
protection which is rated no higher than 15 amps. Any other connection voids warranty and may result in damage to the product, fire, property damage
and injury.
 Keep away from flammable materials.
 Wobblelight ® WL85F must be operated in the upright position only. DO NOT mount Wobblelight ® WL85F units upside down or restrain them such that
they lay on their side.
 Use only approved extension cords in good condition and of the appropriate type, gauge and length.
 Keep extensions cords dry and use ground fault circuit interrupter (GCFI) devices in accordance with all applicable electrical code requirements.