Probuilt Professional Lighting Wobblelight 85w - Manual (Page 2)

 DO NOT operate Wobblelight ® WL85F units with the protective dome and cap missing or broken. DO NOT use Wobblelight ® WL85F units with a broken
housing or damaged electrical cord. Take any damaged units out of service immediately. Replacement bulbs and parts are available from ProBuilt
Professional Lighting or a local authorized distributor or retailer.
 Use ONLY designated replacement bulbs of the appropriate type and wattage.
 DO NOT expose Wobblelight ® WL85F to intense heat or sparks from welding slag, cutting torches, metal saws, etc.
 DO NOT expose Wobblelight ® WL85F to corrosive chemicals, excessive paint spray or abrasive blasting materials.
 Disassembly (other than re-lamping) of Wobblelight ® WL85F will void the warranty. Contact ProBuilt Professional Lighting or a local authorized service
center for repairs and replacement parts.
 DO NOT remove silicone bumpers from fluorescent lamp tubes.
 Avoid excessive bumping and bouncing during operation since mechanical shock can cause shattering of the fluorescent lamp.
 Always operate the lamp with the Wobblelight ® WL85F dome/cap assembly in place to prevent personal injury or property damage.
 Install and remove lamp by grasping the plastic base only.
WARNING: Deviation from these instructions may result in the increased risk of fire, electric shock, injury to persons or property damage.
The Wobblelight
® 85-watt compact fluorescent bulb is self-ballasted and must not be used in any other fluorescent fixture with an external starter or ballast. This device is not
intended for use with emergency exit fixtures or emergency exit lights.
RE-LAMPING AND ASSEMBLY INSTRUCTIONS
Your Wobblelight ® WL85F carton should include the following parts:
 Wobblelight ® WL85F fixture.
 Dome / cap assembly.
 Lamp (85-watt self-ballasted fluorescent bulb).
 Dome screw packet containing four (4) screws (1/4” x 5/8” Phillips button-head sheet metal screw).
If there are any parts missing or damaged, DO NOT contact your Wobblelight ® retailer. Please contact ProBuilt Professional Lighting
Customer Service toll-free at 877-707-0800.
Instructions for Wobblelight
® WL85F assembly:
1. Remove and verify the contents of your Wobblelight ® WL85F carton.
2. Install the bulb into the socket by screwing the lamp firmly but not forcibly into socket in order to avoid breakage.
3. Grasp bulb by the plastic base and not the glass tubes. DO NOT REMOVE SILICONE BUMPERS which are in place to protect the bulb from breakage.
4. Tighten bulb until it is secure in the socket – do not over tighten.
5. Install the Wobblelight
® WL85F dome / cap assembly by aligning the four mounting holes with the four mounting nuts (note that the dome handle should be aligned with the
Wobblelight ® logo). The fit will be snug, but the dome will slide over the four mounting nuts if properly aligned.
6. Secure dome with the four mounting screws – do not over tighten.
7. Your assembled Wobblelight
® WL85F is now ready for use.
8. Use only Wobblelight ® WL85F replacement bulbs.
OPERATION and USE OF Wobblelight ® WL85F