Andrew ES76PK-1 - Manual (Page 24)

Step 11
26
Installation Procedures
After all 16 reflector panels are fastened to ribs. Attach the Cross Struts (300078) by
placing them in-between the Inner Struts (300080) and snug tight the hardware. Refer to
Figure 16.
After all 16 Cross Struts are attached, tighten all hardware.
NOTE: The Cross Struts are the last item to be assembled to insure the ease of
Reflector Panels to be mounted on top side of the ribs.
Figure 16
(300078)
3/8”x1-1/4 Bolt, 9963-165
Washer, 9997-89 (2)
Lockwasher, 9974-63
Nut, 9999-60
(Truss Plate, 300081)
Cross Strut, 300078
(Inner Strut, 300080)
(300080)
The Reflector/Backstructure Assembly is now complete. Refer to the next section on
Reflector Alignment & Theodolite Installation.