SaltDogg TGS07YEL Salt Spreader - Manual (Page 4)

4
TM
SCREW 3/8-16 x 2.0
3018923
SPINNER
PROTECTOR
WASHER FLAT 3/8
NUT 3/8-16
3015926
HINGE LID
SCREW 3/8-16 X 1.0
WASHER FLAT 3/8
NUT NYLOCK 3/8-16
SHIELD #3015707
8. Attach spinner protector #3018923 to spreader frame
as shown in Fig.8. 7. Attach shield #3015707 to trough bracket as shown in
Fig.7
Fig. 8
Fig. 10
9. Attach spinner disk to gear motor shaft as shown
in Fig.9. Secure disk on shaft using clevis pin and cotter
pin.
Fig. 7
3019561
CLEVIS PIN 1420014
COTTER PIN FPC007800075
Fig. 9
10. Install lid #3015926 on to hopper. Place lid on hopper.
Bend hinges outward from center of the hopper. Slide
hinges openings on round protrusions of the lid. Repeat
this operation on opposite side of the hopper. Secure lid on
hopper using lynch pin.
To open lid from ether side of the hopper disengage lynch
pin, bend both hinges outwards and open lid.