Assa 62 - Manual (Page 8)

Rev. A.3, 5/00 Page- 5
2.4 GENERAL INSTALLATION ON INSWINGING DOOR WITH Z BRACKET
In cases where the Magnalock must be mounted on the inswinging side of the door to protect it
from physical assault, the magnet body is mounted flush on the wall above the door frame and
a "Z" bracket is affixed to the door which positions the strike in front of the Magnet (part # Z-32,
Z-62 or Z-82 with the suffix “M” for metric). The model 34 series is not offered in a face
mount version. Securitron's "F" series Magnalocks are used, as they have mounting holes
through the face of the magnet and wire exit to the rear. Figure 5 shows this configuration.
Note that the model 62F has five mounting holes through the face. The “extra” hole is to
provide flexibility in mounting when the magnet body is positioned partly on the top of the
door frame and partly on the wall. In that instance, it becomes possible to secure the model 62
magnet body with three screws which all go into the frame header (many wall types such as
sheet rock do not constitute a secure mounting substrate). Note that when the roll pin
bushings are used, they protrude through the Z bracket and interfere with the Z bracket cover.
If a Senstat lock is being employed, the roll pin bushings must be used to provide insulation.
They should be cut with a hacksaw to function in the bracket. If the lock is not Senstat, omit
use of the roll pin bushings and drill 3/8" (9.5mm) diameter holes for the roll pins instead of
1/2" (12.7mm). Read sections 2.3, 2.3.1, and 2.3.2 for additional general information on
mounting.
FIG. 5: F MAGNET DIMENSIONS
Blind Nut
PN# BN-250 or
PN# BN-6MM (Metric)
(Pack of 24 with tool)
Tamper Cap
PN# FC-1 (Pack of 24)
1/4-20 x 2 1/2" Cap Screw
PN# SCS-25 or
6mm-1mm x 60mm
PN# SCS-60mm (Metric)
Pack of four screws
Go
ld
Wa
sh
er
PN
# F
W
-1
(P
ac
k o
f 2
4)
Model 62F
Model 32F
If "G" option is furnished, the
wire cable emerges from a 3/4"
male; 1/2" female conduit fitting
on the end of the magnet (62
and 82 models only)
Length Width Depth
32 8" 1.88 1.5
(mm) 203 47.8 38.1
62 8" 2.9 1.75
(mm) 203 73.7 44.5
82 12" 2.9 1.75
(mm) 305 73.7 44.5