Progressive International Electronics Omega JR - Manual (Page 10)

Table: Baud Rate Settings
Baud Rate 1 (for POS 1) 2 (for POS 1) 3 (for POS 2) 4 (for POS 2)
2400 ON ON ON ON
4800 OFF ON OFF ON
9600 ON OFF ON OFF
19200 OFF OFF OFF OFF
7. Plug in the wall transformers for the Omega JR and the DBox(es) to the dedicated outlets.
8. Carefully following the vendor’s setup instructions, run the POS application. If the system fails
at this point, contact the vendor for additional instructions.
For the POS/Omega JR system to function properly, the POS must be programmed for the exact
number of dispensers to be controlled by the POS/Omega JR system. (An MPD has multiple
hoses, but is considered to be only two dispensers — one dispenser on either side.)
Diagram: Omega JR to Dispenser
Version 1.0 Page 4 February 2013