Progressive International Electronics Omega2 - Manual (Page 11)

O MEGA 2/O MEGA Lite Universal Site Interface Installation Guide
Version 1.0 October 2011
Page 7
Startup and Configuration
After installing the O
MEGA
Lite or O
MEGA
2, apply power. Once the unit is initialized, the
“Ready” light on the front panel should begin blinking. This can take a couple of minutes.
To configure the unit, connect to the Ethernet, using IP address 192.168.0.250 (default) and
port number 10010 (e.g.,
http://192.168.0.250:10010) The login is:
User admin
Password pie.omega2
A web page will appear. Set up the O
MEGA
, following online instructions. The O
MEGA
Lite
should be set for “Gilbarco” ONLY. The O MEGA 2 should be set according to the options
installed. Enter the correct number of fueling positions for each channel of dispensers.
Diagnostics
To access O
MEGA
diagnostics, use either Telnet or HyperTerminal for connectivity. Set up a
TCP/IP connection, using the configured IP address (default: 192.168.0.250) and port
10004.